Quantcast
Channel: Network Switches
↧

Forum Post: Mast and EPS on - can't console into switch

When I power up the switch, the EPS and Master LED come on at the same time and no other LED come on or blink - see the photo I have attached. I have tried to connect them using RS232 cable and pushed...

View Article


Forum Post: S4048T-ON PBR redirect list - is DENY possible?

I have Dell S4048T-ON switch with firmware 9.11(2.1). I am trying to implement PBR to allow some IP addresses use another internet gateway than everyone - i mean only traffic destined to internet...

View Article


Forum Post: RE: vlan across switches

Thanks for the reply. If both device are on the same switch(ie port 45, 46), they can communicate. Just to expand a bit more on our environment, we installed fiber internet in our building, but...

View Article

Forum Post: RE: Mast and EPS on - can't console into switch

EPS is the redundant External Power Supply. Green indicates that the external power supply is present and operational. It sounds like the switch may be faulty. There is not a whole lot that can be done...

View Article

Forum Post: RE: vlan across switches

With traffic being ok when on the same switch, it sounds like it could be the connection from switch to switch. Is VLAN 1 able to communicate switch to switch? Perhaps try Trunk mode instead of General...

View Article


Forum Post: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

If I connect the SFP+ ports in loop-back they will link up with no issues. If I connect my 2 servers directly together with different SFP+ pcie cards they will link up. If either server is connected to...

View Article

Forum Post: RE: S4048T-ON PBR redirect list - is DENY possible?

I don't know that there is any other way of achieving this within the PBR. What about doing an IP ACL that is implemented on the physical interface that connects to 10.5.1.1? You could permit the...

View Article

Forum Post: RE: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

The firmware is up to date, and you have already tried many of the things that I would suggest. Do you have any other transceivers that can be used? What are the part numbers of the transceivers you...

View Article


Forum Post: RE: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

Apparently, you need the expansion module on the back to provide 10G ports. Which is insane. I swear the specs on dells webpage for 6224 mentions 4 10gb ports. I have ordered 2 expansion modules with...

View Article


Forum Post: RE: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

That's a good call out. Without that expansion module the switch will not support 10Gb connection.

View Article

Forum Post: RE: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

With the modules installed will it increase the port speed of the front SFP ports? or will they always be 1g?

View Article

Forum Post: RE: PowerConnect 6224 will not link SFP+ to my HP DL580 G7

the front port will always be 1g, the expansion modules will have their own ports that are 10g.

View Article

Forum Post: N1500P Switches and PowerConnect 6200

i have had four Dell PowerConnect 6224 switches for the last four years and still running. These are configureed and stacked together with VLANs. Now due to budget constraints we cannot afford to buy...

View Article


Forum Post: RE: Mast and EPS on - can't console into switch

I do not think it is still under warranty. Could you make a guess at which component is faulty? The switch EPS light is now RED, and used to be green. This means that the EPS is also faulty now? Is...

View Article

Forum Post: RE: Mast and EPS on - can't console into switch

Is there an external power supply plugged into the unit? Or any other modules? If so, I suggest unplugging those units and then see if their is any change in behavior.

View Article


Forum Post: RE: N1500P Switches and PowerConnect 6200

Only like model switches can be stacked with one another. You will not be able to add the N1500 to the 6200 stack. You can connect the stack of 6200 switches to the N1500 using the Ethernet ports. You...

View Article

Forum Post: RE: Mast and EPS on - can't console into switch

No change in behavior. But looking at the user manual, the 6200 series has a lifetime warranty it seems. How do you request this warranty?

View Article


Forum Post: RE: Mast and EPS on - can't console into switch

There are some stipulations to the LLW. In some cases the LLW is only valid with the original owner? Are you the original owner of the unit? I will send you a message here on the forums, we can gather...

View Article

Forum Post: RE: Mast and EPS on - can't console into switch

Thank you.

View Article

Forum Post: RE: Dell F10 4810 logs=IP-4-ADDRMOVE...

This is strange, I am having an identical issue w/ Aruba APs and my dell S4048-ON. Every 4 hours, I get a very similar log entry where the MAC associated w/ the AP IP changes from the AP to the...

View Article


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>